Monitor & Control Products
The APCMON2 is designed to monitor any Anacon Power & Controls Solid State Relay Assembly or any "Hockey Puck" style Solid State relay. The same high quality relay specification will be met for this series of products. As the APCMON2 Monitor Card mounts directly to the Input and output terminals of the SSR, standard wiring for input control or output connection will follow standard wiring protocol and it's operation will not be affected by the addition of the APCMON2 Monitor.
​
The monitor card, when wired correctly, will provide an extra level of safety by monitoring the input signal and the output voltage for a shorted SSR, open heater load, loss of AC main supply and DC input power. In critical applications where you need to be assured that the system is always operating properly, the APCMON2 is a smart choice for such applications.
-
APCMON2 Heater Load and SSR Monitor Card
-
Current Transformer Assembly
-
Loop Powered Time Proportioning Module
-
Control Transformer
Ordering Information:
Please note that the APCMON2 Relay Monitor can be mounted to any APC Solid State Relay Assemblies by adding the Suffix
"-MON2", ie. APCXXXX-MON2 to the part number.
Please contact our sales department for pricing and availability.
APCMON2 Heater Load & Solid State Relay Monitor Card
PART NUMBER
DESCRIPTION
Monitors the heater load and solid-state relay for fault conditions
10-50AMP Rated "COOL ONE" Top Mount Current Transformer Assembly
PART NUMBER
LINE
CURRENT
CT OUTPUT
LINE
VOLTAGE
TRANSIENT VOLTAGE
RELAY TYPE
10-50Amps AC
Zener Protected to 15Vdc Max
1ma AC per Amp or 0-10Vdc
24-660Vac
Zero Cross or RTO
APCMAN-1LP 4-20mA Loop Powered Time Proportioning Module
PART NUMBER
COMMAND INPUT
CONTROL OUTPUT
CYCLE TIME
OUTPUT
LINEARITY
4-20mA
-
350mS at 50% output
-
Cycle time greater at ends for optimal output resolution
-
Provides 0-100% time proportioning based on command signal input
-
14mA / 4.2V drive
-
Control output is short protected, direct acting
+/-2% of Full Scale
(+/-1% with -ZS)
See User Manual for
ZS Options.
"COOL ONE" Control Transformer
For Use with Anacon's SCR Controller Cards requiring 24Vac
PART NUMBER
DESCRIPTION
Provides superior isolation and low capacitive coupling.
SCR Power Controller Cards
Power SCR Controller Assembly P/N
Description
Controller Card P/N
APCSCR25/40/50
APCMAN1B
APCSCR25/40/50
SSR Mount Phase Angle Control Module, Volts, mA Input, Pot
APCMAN1P
SSR Mount Phase Angle Control Module, Volts, mA Input, Pot
Address
Anacon Power & Controls
100 Powder Mill Rd. Suite 162
Acton, MA 01720
Phone
TEL: 800-466-9080
TEL: 978-287-0715